10L0L Accelerator & Brake Pedal Switch for EZGO RXV 2008‑up — Direct-Fit Replacement, 12–14V

10L0L Accelerator and brake pedal switch is a direct-fit replacement for EZGO RXV (2008 and newer) that restores pedal sensing and electrical safety functions.

This replacement switch is the compact electrical component mounted in the accelerator pedal assembly that tells your RXV golf cart when you are accelerating or braking. Engineered in polypropylene with electrical ratings suited to 12–14 VDC systems, it replaces several common EZGO part numbers so you can repair your cart quickly without troubleshooting wiring or incompatible parts.

What does this pedal switch do on an RXV golf cart?

The pedal switch detects pedal position and completes or interrupts the on-board control circuits responsible for acceleration and safety interlocks. It handles low current signaling for the controller rather than powering the motor directly, protecting sensitive electronics when the pedal is moved.

• Direct-fit replacement for EZGO RXV models from 2008 onward.
• Mounts in accelerator pedal assembly; interfaces with stock harness and connectors.
• Typical load rating around 3 amps at 12–14 VDC; maximum rating up to 5 amps.
• Durable polypropylene housing resists road vibration and humidity.

How do I know this will replace my original OEM part?

10L0L's pedal switch is designed to match the form, mounting points, and electrical function of several OEM part numbers used on EZGO RXV carts. If your original part number is one of the listed equivalents, this part is a compatible swap without modification.

• Replaces OEM numbers like 612889, 609697, 607605, and 605538.
• Also fits parts listed as 430-003, 575621101, AM143287, K7621-62251.
• Same connector layout and mounting orientation for straightforward installation.

How reliable is the switch and what are its electrical limits?

The housing is molded from polypropylene to provide mechanical stability while the internal contacts are rated for low-voltage control circuits found on most RXV carts. It’s sized for signal-level currents, so it’s best used as a sensor/interlock switch rather than a high-current power device.

• Designed for 12–14 VDC electrical systems common to EZGO RXV carts.
• Typical continuous load about 3 amps; peak allowable current up to 5 amps.
• Built to withstand vibration and everyday use in golf cart environments.

What should I expect during installation?

Installation is straightforward for anyone comfortable removing the accelerator pedal cover and swapping the switch module. No special tools or wiring changes are normally required; the part snaps or bolts into the same location and uses the existing connector.

• Remove pedal trim, unclip or unbolt old switch, disconnect wiring harness.
• Fit new 10L0L switch into pedal assembly, reconnect existing plug, secure in place.
• Test pedal response and interlock function before full ride use.

Who is this for: Owners and technicians who need a direct replacement accelerator/brake pedal switch for EZGO RXV golf carts (2008 and newer). It's ideal for repairing worn or intermittent pedal sensors, restoring safety interlocks, or replacing obsolete OEM parts with a compatible, rated unit that matches original fit and function.