ALL-CARB Carb Repair Kit 2-Pack for Johnson/Evinrude 18–75hp with Replacement Floats & Gaskets

ALL-CARB 2 Pack Carb Repair Kits with float replacements restore proper fuel flow and sealing for Johnson/Evinrude outboard carburetors from 18 up to 75 horsepower.

If your Johnson or Evinrude outboard is running rough, flooding, or idling inconsistently, the problem often traces to worn carburetor components. This two-pack repair kit from ALL-CARB includes the common replacement parts and new floats compatible with part numbers 392061, 396701, 398729, 18-7222 and 9-37107, and fits a wide range of 18–75hp models. The kit supplies both kits and floats so you can service two carburetors or keep a spare on board.

How will these kits improve my engine’s performance?

Replacing degraded gaskets, needles, and floats helps the carburetor meter fuel more accurately, reducing stalling, hard starting, and uneven idling. The new components restore sealing and float height, which affects fuel level in the bowl and mixture consistency.

• Includes replacement floats to correct fuel levels in the bowl.
• Fresh gaskets and O-rings prevent vacuum and fuel leaks.
• New needles and seats improve choke and idle response.

Which Johnson and Evinrude models does this fit?

The kit is intended for a broad set of Johnson/Evinrude outboards in the 18–75hp range. Verify your engine’s part number against 392061, 396701, 398729, 18-7222, or 9-37107 to confirm compatibility before purchasing.

• Covers common 18, 20, 25, 28, 30, 35, 40, 45, 48, 50, 55, 60, 65, 70 and 75 hp models.
• Cross-references known OEM part numbers for straightforward replacement.
• Two kits let you service dual carburetor engines or keep an extra spare.

What’s included and how difficult is installation?

Each kit supplies the typical consumable parts used during a carb overhaul: floats, gasket sets, needles, seats and related small components. Basic mechanical skill and simple hand tools are sufficient for many DIYers, but professional installation is recommended if you’re unfamiliar with carburetor setup or float height adjustment.

• Two complete carb repair kits with floats and full gasket sets.
• Install requires disassembly of the carburetor bowl and careful reassembly.
• Float height and needle seating must be checked for correct operation.

How should I verify this is the right part before ordering?

Match the part numbers stamped on your old components or confirm fitment in your engine’s service manual. Compare the listed replacements (392061, 396701, 398729, 18-7222, 9-37107) with the numbers on your carburetor body and parts to ensure compatibility.

• Locate OEM numbers on your existing carburetor parts for direct comparison.
• Consult the engine manual or a parts diagram for model-specific confirmation.
• When in doubt, photograph the carburetor and contact a mechanic or parts supplier.

Who is this for: Boaters, marine mechanics, and DIY enthusiasts who maintain Johnson or Evinrude 18–75hp outboards and need a reliable, cost-effective way to replace worn carburetor parts. The ALL-CARB two-pack is useful for owners of twin-carb engines, service shops needing a spare, or anyone prepping a vessel for a season on the water. Always confirm part numbers before installation and consider professional help for precise float adjustments and tuning.