Aspligo Front Wheel Bearing Hub Pair for Nissan Altima 2007-2013 2.5L — OE-fit, Integrated ABS Encoder

This pair of front wheel bearing hub assemblies is built to OE-compatible specifications to restore wheel alignment, smooth rotation, and consistent ABS signal performance for the specified Altima years. Each hub includes an integrated encoder ABS sensor and arrives ready for installation without bearing clearance adjustments. The assembly is forged for strength, fitted with upgraded seals to retain lubrication and resist corrosion, and designed to meet the flange, bolt pattern, and pilot dimensions used by Nissan originals.

What vehicles and positions does this hub fit?

These assemblies are intended for the front wheels of Nissan Altima model years 2007 through 2013 with the 2.5L 4-cylinder engine. Confirm fitment using the vehicle selector on the product page or by matching the OE/interchange numbers listed below before ordering.

• Compatible: Nissan Altima 2007–2013 (2.5L 4-cylinder only)
• Installation position: Front wheel (left & right sold as a pair)
• OE / Interchange: 402029HC0A, 40202JA000, 40202JA010, 40202ZX00A

How does this hub assembly improve durability and performance?

Aspligo uses upgraded forging and sealing methods to strengthen the hub body and protect the bearing from contaminants. The result is improved load tolerance under acceleration, braking, and cornering, plus better resistance to rust and heat during extended service.

• Forged metal structure for increased toughness and fatigue resistance
• Enhanced seal design to retain grease and keep out water and debris
• Heat-dissipating surfaces and corrosion-resistant finishes for longevity

What are the key specifications and installation notes?

The hub assembly matches OEM geometry: 5-lug pattern, encoder-type ABS sensor, and the listed flange and pilot diameters. Installation is straightforward but requires proper tools and technique; this unit is supplied pre-set and does not require bearing clearance adjustments.

• Flange diameter: 5.35 in; Bolt circle: 4.50 in; Pilot diameter: 3.66 in
• Brake pilot diameter: 2.68 in; Flange type: 4-bolt; Wheel studs: 5
• Do not disassemble the hub, remove packaging only before install, replace coaxially

Will the ABS sensor and electronics work with my Altima?

Each Aspligo hub includes an encoder ABS ring designed to interface with the vehicle’s factory wheel-speed sensing system. Verify compatibility with the Altima’s ABS module and avoid installing the hub in the reversed orientation to preserve sensor function.

• Encoder ABS integrated to deliver wheel-speed pulses to factory module
• Ensure correct orientation during installation; magnetic coding rings are directional
• Confirm electrical connector fit and ABS fault codes are cleared after replacement

Who this is for: This pair of Aspligo 513294 front wheel hub assemblies is aimed at DIYers and professional technicians replacing worn or noisy front hubs on Nissan Altima 2007–2013 2.5L models who want an OE-spec, ready-to-install solution. Choose this product if you need matched left and right hubs with integrated ABS encoders, robust sealing, and forged strength to handle daily driving loads and occasional harsh road conditions. Always verify vehicle year, make, model, and OE interchange numbers before purchasing to ensure a complete fit.