Bolvixor Recessed D-Ring Tie Down Anchors 4-Pack — 6,000 lb Galvanized, 6.5-inch Backing Plates

Bolvixor Recessed D-Ring Tie Down Anchors are a 4-pack of flush-mount, galvanized steel tie-downs rated to a 6,000 lb assembly break strength with 6.5" backing plates for heavy cargo security.

These recessed D-ring anchors install flush into trailer floors, truck beds, or RV decks and provide heavy-duty attachment points that fold flat when not in use. The kit includes four D-ring anchors, matching face plates and oversized 6.5" x 6.5" backing plates to spread load across the mounting surface, plus bolts and screws for immediate installation. Built from galvanized steel, the anchors resist corrosion from weather and road salt while supporting straps, chains, or ropes for hauling ATVs, motorcycles, construction equipment, or commercial pallets.

How much load can each D-ring safely handle?

Each anchor in the Bolvixor kit is engineered to a 6,000-pound assembly break strength under ideal conditions. That rating applies to the assembled anchor and mounting system; overall capacity depends on proper installation, backing plate use, and the strength of the mounting surface.

• Individual anchor rated: 6,000 lb assembly break strength.
• Galvanized steel construction for durability under load.
• Use provided 6.5" backing plates to prevent pull-through.
• Confirm mounting substrate (wood, steel) meets load requirements.

What hardware and parts are included in the kit?

The Bolvixor four-pack arrives as a complete mounting solution so you can fasten anchors without extra trips for bolts. Each kit includes face plates, oversized backing plates and the necessary bolts and screws sized to the anchor holes for straightforward installation.

• Four recessed D-ring anchors with integrated face plates (4.88" x 4.88").
• Four 6.5" x 6.5" heavy backing plates to distribute load.
• Matching bolts and screws for a secure bolt-on installation.
• Hardware sized to fit common trailer and truck bed thicknesses.

How do these anchors install and store when not in use?

Installation is bolt-on and straightforward: cut or recess a hole, position the face plate, and secure the backing plate beneath the surface with the provided fasteners. The ring sits flush when not in use to eliminate tripping hazards and to allow rolling or sliding cargo over the anchor location.

• Flush design folds flat to avoid interference with cargo or foot traffic.
• Simple bolt-on mounting with provided screws and bolts.
• Backing plates reduce chance of bolt tear-through on wood or thin metal.
• Lift-to-use ring provides quick tie-down access when needed.

Which vehicles and loads are these best suited for?

These recessed D-ring anchors work across a wide range of transport platforms—utility trailers, enclosed trailers, flatbeds, pickup beds, and RV storage floors. They are intended for securing medium to heavy items like ATVs, UTVs, motorcycles, furniture and palletized cargo, but the installation surface must be structurally sound for the published rating to apply.

• Ideal for ATVs, motorcycles, and equipment transport.
• Suitable for commercial pallets and heavy furniture moves.
• Use on wood, steel, or composite floors with proper backing support.
• Works in trailer, truck bed, and RV cargo areas.

Who is this for: The Bolvixor recessed D-ring kit is aimed at trailer and truck owners, fleet managers, contractors and DIY installers who need dependable, low-profile anchor points for heavy cargo. If you haul motorcycles, ATVs, machinery or palletized loads and want corrosion-resistant hardware that mounts flush and spreads load to prevent fastener failure, this kit provides a ready-to-install solution. Always inspect your mounting surface and follow safe load practices when securing heavy items.