Carbhub Front ABS Wheel Speed Sensor 2-Pack for Dodge Journey/Avenger & Chrysler 200/Sebring Front Left & Right Direct-Fit

Carbhub front ABS wheel speed sensors (2-pack) replace faulty front-left and front-right sensors to restore accurate wheel-speed readings for your vehicle’s ABS and traction systems.

If your dashboard shows ABS or traction-control warnings, or if braking feels less stable in slippery conditions, worn wheel speed sensors are a common cause. This Carbhub two-piece set is designed as a direct-fit replacement for a range of Dodge and Chrysler models, matching factory-style connectors and mounting points so you can swap them in without cutting wires or special adapters.

Which vehicles do these sensors fit?

These sensors are engineered to match the front left and front right wheel positions on several Dodge and Chrysler years and models. Verify part numbers against your vehicle’s OEM reference to ensure compatibility before installing.

• Fits Dodge Journey 2009–2020
• Fits Dodge Avenger 2008–2014
• Fits Chrysler Sebring 2007–2010
• Fits Chrysler 200 2011–2014

How do these replace the original (OEM) parts?

Carbhub sensors correspond to multiple OEM references so they integrate with your vehicle’s existing wiring and connectors. They’re made to align with factory mounting points for a secure, vibration-resistant fit and avoid the need for splicing or re-routing harnesses.

• Cross-references: ALS2408, ALS2410 and OEM numbers such as 05085823AB, 05085822AC
• Factory-style plug for plug-and-play replacement
• No permanent modification—reversible to stock if needed

What improvements do these sensors provide once installed?

Replacing defective sensors clears erroneous ABS/traction warnings and restores proper wheel-speed data to the vehicle’s control modules. That allows the anti-lock and stability systems to function as intended, improving braking control and vehicle stability under load or low-traction conditions.

• Eliminates ABS/traction-control warning lights caused by sensor failure
• Restores reliable wheel-speed input for better brake modulation
• Helps maintain consistent traction-control and stability responses

Is installation difficult and what should I expect?

These are direct-fit front sensors designed for straightforward installation by a competent DIYer or mechanic. Basic tools are typically sufficient; you’ll remove the wheel and brake components as needed to access the sensor mount, unplug the old unit, and bolt the replacement in place.

• Includes two sensors: front-left and front-right
• Uses original connector style—no cutting or splicing
• Typical install time: 30–90 minutes per side depending on access and experience

Who this is for: Drivers of compatible Dodge Journey, Dodge Avenger, Chrysler Sebring, or Chrysler 200 models who are experiencing ABS or traction-control warnings, inconsistent braking behavior, or failures in wheel-speed reporting. It’s also suitable for mechanics and DIYers looking for a cost-effective, OEM-referenced replacement that installs without electrical modification.