Cxdar LED Third Brake Light Assembly for 2003–2016 Ford Expedition & Lincoln Navigator — RED, Direct-Fit IP65

Cxdar's Third Brake Light LED is a direct-replacement high-mount stop lamp engineered to restore bright, reliable rear signaling for 2003–2016 Ford Expedition and 2003–2016 Lincoln Navigator models.

If your factory center high-mount stop light is cracked, dim, or water-damaged, this Cxdar assembly offers a weather-resistant, plug-and-play alternative that matches the original fit and mounting points for late-model Expeditions and Navigators. The unit uses low-power LEDs housed in impact-resistant ABS with a sealed gasket to keep moisture and dust out, and it’s shaped to align with the third-brake opening so you won’t need major modifications.

How does this LED third brake light fit my 2003–2016 Ford Expedition or Lincoln Navigator?

The Cxdar assembly is designed as a direct fit for the specified year ranges, using the same screw locations and electrical connector style as the original equipment. That means minimal trimming or wiring changes in most installations.

• Compatibility: 2003–2016 Ford Expedition; 2003–2016 Lincoln Navigator
• Mounting: direct bolt-in using factory holes
• Connector: plug-and-play harness intended to match OEM socket
• Installation note: start screws loosely to avoid cracking the housing

Will the light hold up to rain, snow, and road debris?

Cxdar builds the lamp with an IP65 level of protection and a sturdy ABS body, so it resists spray, dust, and light jets of water from road driving. The sealed gasket and protective lens reduce the chance of condensation and salt corrosion that commonly shorten aftermarket lamp life.

• Ingress rating: IP65 splash- and dust-resistant
• Construction: impact-resistant ABS housing and durable lens
• Sealing: integrated gasket to block moisture and particulates
• Longevity: designed to limit water-related failures and corrosion

How difficult is installation and what tools will I need?

Installation is intended to be straightforward for a competent DIYer: unplug the old lamp, remove the retaining screws, position the new assembly, and reconnect the harness. Cxdar recommends hand-screwing the fasteners at first so the plastic case isn’t overstressed, then tightening to secure fit once aligned.

• Skill level: basic to moderate automotive DIY
• Tools: hand screwdriver, panel trim tool, optional socket set
• Time: typically 15–30 minutes depending on access
• Tip: avoid fully tightening screws until correctly seated

What performance and safety features does the LED unit provide?

The LED array delivers brighter, faster-illuminating brake signaling than many aged incandescent units, while using less electrical power. The improved visibility helps other drivers notice braking sooner in many driving conditions, and the sealed design keeps the light working reliably over time.

• Light source: high-efficiency LEDs for quick, bright stop indication
• Power draw: low consumption to reduce vehicle electrical load
• Visibility: clear, high-contrast red output for rear detection
• Durability: lens and housing built to resist everyday road damage

Who is this for: Owners of 2003–2016 Ford Expedition or 2003–2016 Lincoln Navigator vehicles seeking a direct-fit replacement for a damaged or dim third brake light — especially those who want a weather-resistant LED upgrade that installs quickly and improves rear signaling without rewiring or body modifications. It’s suitable for DIY installers and technicians alike; if you need help, Cxdar provides support for product questions and warranty inquiries.