Delphi ABS speed sensor SS10311 — OE-equivalent direct-fit, corrosion-resistant housing

The Delphi SS10311 ABS speed sensor is an OE-grade wheel-speed sensor designed to restore accurate ABS and traction control input with direct-fit compatibility for specified vehicle applications.

Engineered by Delphi — an original-equipment supplier with decades of automotive experience — the SS10311 delivers the precise vehicle-speed signal needed by anti-lock braking and stability systems. Built for vehicle-specific fitment, this sensor replaces worn or damaged units to help return system responsiveness and diagnostic clarity without modifying factory wiring or brackets.

How does the SS10311 ensure correct ABS and traction readings?

The sensor converts wheel or tone-ring movement into an electrical signal the vehicle’s controller uses to monitor wheel speed. Delphi designs the sensing element and connector to match OE signal characteristics, minimizing calibration differences and fault codes after installation.

• OE-equivalent signal output tuned for original controller expectations
• Factory-matching mounting and electrical connector for consistent alignment
• Corrosion-resistant materials to preserve electrical continuity

What makes this sensor a dependable replacement?

Delphi applies decades of supply experience to component durability, using materials and tolerances aligned with original parts. That focus reduces premature failures and keeps replacement intervals similar to the factory schedule.

• Vehicle-specific fitment prevents stress on mounting points or wiring
• Robust housing and seal design protect the internal sensing element
• Manufactured to match OE electrical and mechanical specifications

How easy is installation and compatibility with my vehicle?

The SS10311 is a direct-replacement, designed to plug into the existing harness and bolt into the original sensor location. For best results, confirm the listed OEM equivalent or vehicle application before purchasing to ensure a correct match.

• Direct-fit part tailored to specific models, reducing installation time
• OEM-equivalent part reference: FORD%F3TZ2L373A for cross-checking fitment
• No splicing or adapter parts typically required when matched to the vehicle

What maintenance or checks should be done after replacing the sensor?

After installation, it’s good practice to clear any ABS-related fault codes and perform a road test to confirm the system reports wheel-speed correctly. Inspect the mating connector and tone ring for damage before and after mounting.

• Scan and clear ABS/traction codes after fitting to reset system learning
• Check connector pins for corrosion and ensure secure engagement
• Verify tone ring and bearing condition to avoid re-triggering faults

Who is this for: The Delphi SS10311 ABS speed sensor is intended for technicians and DIY installers seeking a direct-fit, OE-quality replacement for compatible vehicles. It’s a practical choice when restoring accurate wheel-speed feedback to ABS, stability control, or traction systems without modifying factory components. Verify vehicle application and the OEM-equivalent part number before purchase to ensure proper fitment.