nibbi 24mm carburetor for Predator 212cc/224cc/196cc — 48mm flange, anodized performance with adjustable jets

NIBBI's 24mm performance carburetor is a direct-replacement, fully adjustable carb designed to improve throttle response and tuning flexibility for Predator 212cc/224cc/196cc and similar 6.5HP engines.

If your mini bike, go-kart or small utility engine runs a GX160/GX200-style carburetor, this NIBBI unit offers a durable anodized body, multiple jets, and tunable settings so you can match fuel delivery to different altitudes, loads, or performance preferences. The kit is supplied ready for installation with a set of main jets and a pilot jet, and it fits engines with a 24mm throat and a 48mm flange bolt pattern.

Will this carburetor fit my Predator 212cc or similar engine?

Check two critical measurements before buying: the inner throat diameter and the flange bolt spacing. NIBBI's carb has a 24mm internal bore and a 48mm flange bolt pattern; if your engine matches these, the physical fit is likely compatible.

• Inner diameter (engine side): 24mm
• Carburetor flange hole spacing: 48mm
• Fits: Predator 212cc, 224cc, 196cc and GX160/GX200-style engines
• Contact the seller if you need verification before purchase

How does the NIBBI carb help with tuning and performance?

This carburetor gives you several adjustable elements—main jet, pilot jet, needle position, and air screw—so you can fine-tune mixture and throttle response for different conditions. That flexibility helps you optimize for fuel economy, low-end idle stability, or top-end power depending on your setup.

• Includes main jets #108, #110, #115 for quick jet changes
• Pilot jet #35 included to improve idle and low-throttle behavior
• Needle position and air screw adjustments for midrange tuning
• Manual included to guide initial jetting and adjustments

What materials and build details make this carburetor durable?

The NIBBI carburetor body is anodized and coated to resist wear and corrosion, which is useful for machines exposed to dirt, moisture, and vibration. The finish and construction are aimed at longer service life compared with untreated cast parts.

• Anodized surface treatment for corrosion and abrasion resistance
• Coated components suited to rugged operating environments
• Hardware and jets supplied to replace or tune worn factory parts

What comes in the kit and what tools will I need?

The kit ships with the carburetor, three main jets, one pilot jet, and an installation manual to help with mounting and baseline jet selection. Basic hand tools and a small screwdriver are typically sufficient for installation and initial tuning.

• Included: carburetor, main jets (#108, #110, #115), pilot jet (#35), manual
• Recommended tools: screwdrivers, socket set, and basic wrenches
• Allow time for test rides and incremental adjustments after install

Who is this for: This NIBBI 24mm carburetor is intended for DIY mechanics, racers, and hobbyists who maintain Predator 212cc/224cc/196cc or GX160/GX200-style engines on mini bikes, go-karts, or small utility machines. It suits users who want a more tunable replacement than a stock carb—especially if you need corrosion-resistant hardware, multiple jet options, and fine control over mixture and throttle response. If you’re unsure about fitment, measure the 24mm throat and 48mm flange spacing or reach out for fit confirmation before ordering.