Partsam LED Trailer Fender Lights — 2pc Red/Amber Clearance Markers for Trailers over 80" | Sealed, Bracket-Mounted

If you tow a wide trailer, clear and compliant marker lights are essential for visibility and safety. This Partsam assembly combines an amber front-facing LED and a red rear-facing LED in a single low-profile bracket that mounts to the top or side of your fender. The sealed lenses resist water and road grime, and the two-wire design simplifies installation by providing a power lead and a ground.

How does this fender light set improve trailer visibility?

The paired amber and red LEDs identify the trailer’s maximum width and signal front and rear orientation to other drivers. Bright single-diode LEDs are visible in daylight and at night without the bulk of traditional fixtures.

• Amber LED points forward to act as the front clearance marker.
• Red LED faces rearward to act as the rear clearance marker.
• Low-profile housing reduces snag risk and wind resistance.
• Sealed, waterproof lens keeps illumination consistent in wet conditions.

Will these lights fit my trailer and how do they mount?

The bracketed assembly is intended for trailers wider than 80" and installs on either the top or side of fenders. The set includes left- and right-side units configured for driver and passenger sides, so you get proper orientation without swapping lenses.

• Pre-wired 2-wire design: one power lead and one ground wire.
• Mounts on top or side of fender using the included bracket points.
• Left unit for driver side, right unit for passenger side — orientation-ready out of the box.
• Compact housing dimensions to fit most standard trailer fenders (see product images for scale).

How durable and weatherproof are these LEDs?

Partsam designed the lights to withstand road conditions — the lenses are sealed to keep moisture and dirt out while the LEDs themselves run cool and long-lasting. The simple, rugged construction prioritizes reliable performance over time without frequent maintenance.

• Sealed waterproof lenses prevent water intrusion and lens fogging.
• Low-profile single-diode LEDs generate less heat and draw minimal current.
• Sturdy bracket and housing resist vibration and road impacts.
• Pre-wired connections minimize exposed wiring and potential failure points.

What should I know about installation and wiring?

Installation is straightforward for anyone comfortable with basic trailer wiring. The two wires simplify hookup: attach the power lead to the trailer’s clearance light circuit and secure the ground to chassis metal.

• Two-wire system: one power lead and one ground wire per unit.
• Mounts with screws through the bracket into fender material; confirm clearance before drilling.
• Polarity and orientation are fixed—amber must face forward and red must face rearward.
• Verify local lighting regulations for placement and brightness requirements.

Who is this for? This Partsam fender light set is intended for owners of wide trailers (over 80"), including utility trailers, flatbeds, RVs, and commercial haulers who want a compact, weather-resistant, and easy-to-install clearance marker. It suits DIY installers and fleet managers who need reliable, low-current LED illumination to mark trailer width and orientation without bulky housings or complex wiring.