Poli Glow Mitt Applicator microfiber applicator mitt - reusable damp pad for faster, even Poli Glow coverage

The Poli Glow® Mitt Applicator is a reusable microfiber applicator designed to deliver smooth, consistent Poli Glow coatings faster and with less waste than the original 7" chamois.

If you use Poli Glow surface finish, the right applicator makes a big difference. This Mitt Applicator replaces the traditional 7-inch chamois, offering a damp, comfortable microfiber surface that spreads Poli Glow evenly, helps control product usage, and speeds application over large sections. The mitt is intended for use with disposable gloves underneath and is simple to rinse and re-dampen during work.

How do I prepare the Poli Glow Mitt before use?

Preparation is quick but important for even results. Start by wetting the mitt with fresh water, wringing it out, then wrapping it in a towel and wringing again so the fabric is damp, not dripping. Keep a towel and a rinse container nearby so you can restore the correct moisture level between sections.

• Dampen with fresh water and wring until just moist.
• Wrap in a towel and wring again to remove excess water.
• Wear rubber or disposable gloves under the mitt at all times.
• Rinse and repeat the dampening process as needed during application.

What is the correct technique to apply Poli Glow with the mitt?

Use the mitt like a flat pad rather than a sponge—drizzle product onto the palm area and wipe in straight strokes. Work a 4' x 6' section at a time, wiping top-to-bottom or side-to-side (avoid circular motions) and allow each thin coat to dry before applying the next.

• Drizzle several lines of Poli Glow onto the mitt’s palm area.
• Wipe in one direction across a 4' x 6' area—no circular rubbing.
• Each coat dries in about 1–2 minutes depending on temperature.
• Apply at least six coats per section for recommended build and finish.

How should I care for the microfiber mitt during and after a job?

The mitt will need occasional rinsing while working to avoid product buildup; restore its dampness using the towel method described earlier. After the job, launder the microfiber according to fabric care guidelines—avoid fabric softener and high heat to preserve absorbency and performance.

• Rinse the mitt periodically during application to remove excess finish.
• Keep the mitt damp, not wet, throughout use for consistent spread.
• Wash after use without fabric softener and air-dry or low tumble.
• Inspect for wear and replace if texture degrades and performance drops.

Who is this for? The Poli Glow Mitt Applicator is aimed at DIYers, contractors, and detailers who apply Poli Glow coatings over floors, counters, or other large surfaces and want a faster, more controlled method than a small chamois. It suits anyone seeking a reusable, easy-to-rinse applicator that helps lay down thin, uniform coats with minimal waste. Note: always follow Poli Glow product instructions and use disposable gloves under the mitt for safe handling.