TAKPART Universal Split CV Boot Kit — Stretchable 19–35mm Shaft, Fits 56–110mm CV Joints, Includes Pliers & Clamps

TAKPART Universal Split CV Joint Boot Kit is a stretchable, cut-to-fit replacement gaiter that repairs constant velocity joints without removing the joint, compatible with shafts 19–35mm and CV joints 56–110mm.

When a torn CV boot starts leaking grease, the TAKPART split boot kit gives you a fast, low-cost repair option. The kit’s stretchable, split design slips over the shaft and seals the joint in place so you can avoid expensive disassembly. Made from a durable, oil- and abrasion-resistant material, this universal boot is sized to cover most passenger and light-duty vehicle CV joints and includes the clips and tools to complete the job cleanly.

How does the split design speed up CV boot repairs?

The split construction is pre-slit along one side so it opens and wraps around the driveshaft without removing the CV joint. That saves time and preserves the original assembly, which is particularly useful on older or hard-to-disassemble axles.

• Pre-slit boot fits around assembled shafts 19–35mm in diameter.
• Stretchable elastomer allows a snug fit over CV joints 56–110mm across.
• Includes ties and pliers to clamp the boot securely in place.
• Instruction sheet and gloves included for cleaner, faster installation.

Will this boot resist grease, grit, and wear on the road?

Yes — the material is formulated to resist common contaminants and mechanical wear that break down standard gaiters. That durability extends service life and helps keep lubricating grease inside the joint to prevent premature wear.

• Oil- and grease-resistant compound resists swelling and degradation.
• Abrasion- and tear-resistant construction reduces the risk of new leaks.
• Impact resilience helps withstand road debris and flex cycles.

How do I choose the right size and fit this universal boot?

Measure the driveshaft diameter and the widest part of the CV joint to confirm compatibility within the specified ranges. Because the material stretches and can be trimmed, you can fine-tune the fit for many vehicle makes and axle designs.

• Shaft compatibility: 19–35mm diameter.
• CV joint coverage: 56–110mm maximum circumference/diameter range.
• Trim-to-fit design lets you cut excess material for a custom seal.
• Included clamping pliers ensure even, secure fastening of supplied ties.

What comes in the kit and what tools will I need?

The TAKPART kit is intended as a complete repair package for a single boot replacement, including consumables and a tool to secure the clamps. You’ll only need a few basic hand tools to access the joint and trim the boot to shape if necessary.

• Contents: split CV boot, multiple CV boot ties, fitting pliers, disposable gloves, and instructions.
• No joint removal required in most installs; basic hand tools for axle access are helpful.
• Trim the boot with scissors or a utility knife following the guidance sheet.

Who is this for? Mechanics, DIY enthusiasts and fleet technicians who need a fast, economical solution for torn CV boots will find this kit valuable. It’s especially suited for vehicles where removing the CV joint is difficult or costly, for roadside repairs, and for preventative maintenance on older axles. If your driveshaft diameter is between 19 and 35mm and the CV joint falls inside the 56–110mm range, this TAKPART kit gives you a robust replacement option with the clips and pliers needed to finish the job cleanly.