TOMOON Washer Rotor Position Sensor 6501KW2002A for LG washers — direct-fit OEM replacement, PTFE durable

If your LG front-load washer shows LE or E0 errors, won’t tumble, or spins slowly, a faulty rotor position sensor (also called RPS or MPS) is a common culprit. TOMOON’s 6501KW2002A sensor is made to match OEM fit and function for many LG and Kenmore models. It arrives pre-tested and sized roughly 2.9" x 2.2" to replace worn or damaged units and help restore normal washer operation when the fault truly lies with the sensor.

How will this sensor fix washing machine errors?

The rotor position sensor tells the washer’s electronic control board the rotor’s exact speed and direction. If the sensor fails or the connection is poor, the board can’t control the motor and will trigger LE (locked rotor) or E0 errors and abnormal behavior like no spin or slow spin. Replacing a defective sensor often clears those symptoms when wiring and other components are intact.

• Detects rotor position and speed for accurate motor control
• Addresses LE and E0 error codes when sensor is the root cause
• Restores correct tumbles, agitation, and spin rates
• Simple swap that returns the motor feedback pathway to normal

Is the TOMOON 6501KW2002A easy to install?

Yes — the sensor is designed for straightforward replacement using basic hand tools. The unit is molded from PTFE-grade plastic for stability, and most users can change it in about 10 minutes. Always disconnect power and inspect wiring connectors before and after installation.

• Approximately 10-minute install with a flat screwdriver
• Pre-shaped for direct OEM-style fit on compatible models
• Durable PTFE construction resists wear and heat
• Visual guide: compare part sticker to confirm part number

Which washers does this part fit and how do I confirm compatibility?

This TOMOON sensor replaces LG part numbers 6501KW2002A / 6501KW2002B and fits many older LG and Kenmore front-load models listed by manufacturer. Newer 2018+ models with integrated inverter boards may not be compatible. Always compare the sticker on your original sensor or provide your washer’s model and serial number for verification.

• Replaces OEM part numbers: 6501KW2002A, 6501KW2002B, AP4440680 and equivalents
• Fits many LG front-load models including WM0532HW, WM2016CW, WM3050CW, WM3575CW, WM4270HVA, WM8000HVA, and others
• Not guaranteed for 2018+ integrated inverter models — check original part label
• Contact seller with model & serial for compatibility checks within 12 hours

What should I check before replacing the sensor?

Loose or damaged wiring causes many false sensor failures. Over 30% of reported sensor problems are actually bad connectors or harness issues. Inspect the wiring harness and connections first; if the wiring is sound and the error persists, the TOMOON sensor is an appropriate replacement.

• Inspect wiring harness and connector for breaks or corrosion
• Verify the original sensor sticker lists 6501KW2002A/B
• Confirm error codes are LE or E0; other codes indicate different faults
• Keep original connector orientation when installing new sensor

Who is this for: The TOMOON 6501KW2002A sensor is aimed at DIY homeowners, repair technicians, and appliance shops replacing failed rotor position sensors on qualifying LG and Kenmore front-load washers. If you’re troubleshooting LE or E0 codes, have verified wiring integrity, and your original sensor part number matches 6501KW2002A or 6501KW2002B, this direct-fit assembly provides an economical, tested replacement to get your washer running correctly again.