VOSAREA Car Lifting Pads 4-Pack — Round Rubber Jack Pads, Heavy‑Duty Non‑Slip Support

VOSAREA 4pcs Car Lifting Pads are heavy‑duty round rubber jack pads that protect vehicle frames and jack points while providing stable, non‑slip support for lifts and jacks.

These four rubber lift pads are made to sit between a vehicle's lift point and a jack or hoist, cushioning metal‑to‑metal contact and helping distribute weight across the pad's recessed center. Constructed from resilient, soft rubber with a textured surface and engineered recess for frame rails, each pad is sized to fit a standard 4.5‑inch backing plate with 2.75‑inch bolt hole spacing. They are intended for general automotive maintenance—DIY and professional use—on cars, trucks and SUVs. Follow the mounting and seating guidance to maximize longevity and safety.

How do these pads protect my vehicle during a lift?

The pads create a rubber buffer that prevents direct metal contact between the jack and the vehicle’s underride or pinch weld. That cushioning reduces scratches, dents and frame deformation and helps absorb concentrated pressure points.

• Soft but durable rubber reduces abrasion and marring to painted or plated surfaces.
• Recessed center helps cradle frame rails, keeping the load centered.
• Textured face reduces slippage when jacking under load.
• Evenly spreads pressure to lower the risk of concentrated damage.

Will these pads fit my lift or hoist backing plate?

Each pad has a nominal outer diameter of 11.4 cm (4.5 in) and bolt hole spacing of approximately 7 cm (2.75 in). Confirm the diameter and bolt pattern of your existing backing plate to ensure a secure, flush fit before use.

• Outer diameter: 11.4 cm / 4.5 inches — measure your plate to match.
• Bolt spacing: ~7 cm / 2.75 inches — check against your lift's tabs.
• Designed for full‑surface engagement—avoid off‑center or narrow contact points.
• Not intended as a universal guarantee; verify fit for non‑standard lifts.

How much weight can each rubber jack pad handle safely?

Single pads are commonly rated in the 2,500–3,500 lb range, but real safety depends on load distribution and the contact area. Proper placement inside the recessed area and full surface engagement are essential for the pad to carry its rated share without splitting or deforming.

• Rated capacity reference: 2,500–3,500 lbs per pad when fully seated.
• Ensure broad, flush contact—avoid edge loading or narrow metal ridges.
• Confirm vehicle weight and lift point arrangement before using.
• Replace pads showing cuts, severe compression, or uneven wear.

How should I position and maintain these lifting pads for safe use?

Place the vehicle so its lift point sits squarely in the pad recess, making sure the weight settles across the main body of the rubber rather than toward the rim. Inspect the pad and backing plate for debris or damage before every lift, and store pads away from harsh solvents and extreme heat to prolong service life.

• Check for full contact in the recessed well; reposition if edges lift.
• Keep mating surfaces clean and free of grease or metal shards.
• Swap pads if you detect cracks, splitting, or permanent flattening.
• Use on compatible vehicles (cars, trucks, SUVs) and lifts only.

Who is this for? These VOSAREA rubber jack pads are aimed at garage hobbyists, home DIY mechanics and professional shops that need a cost‑effective way to protect vehicle undercarriage points and extend the life of jack backing plates. If you routinely lift cars, trucks or SUVs and want to avoid metal‑on‑metal contact, these pads offer simple protective cushioning—provided you confirm fit and follow proper seating and load distribution guidelines.