XIKOBY 24V Controller and Throttle Kit for Razor E200/E300 MX350 MX400 (V13–V36) — 24V controller, charger port & grips

This replacement control assembly combines a 24V controller module, 4-pin throttle, charger port, handlebar grips and an on/off switch so you can quickly repair or upgrade compatible Razor models. Designed to fit specific model revisions, the kit uses constant current control logic and built-in overload protection to stabilize motor output and protect the battery pack from damaging draw. Before ordering, check your scooter or dirt bike model version and throttle connector type to ensure compatibility.

Which Razor models will this XIKOBY control assembly fit?

The kit fits Razor E300 versions 20 and up, E200 versions 13–23, MX350 versions 33–36 and MX400 versions 33–36. It is made to match the connector layout and mounting points used on those revisions.

• Compatible: E300 (V20+), E200 (V13–23), MX350 (V33–36), MX400 (V33–36)
• Not interchangeable with other controller model numbers (see details below)
• Confirm your vehicle version sticker or existing controller model before purchase

How does the controller protect the battery and motor during use?

The XIKOBY module uses constant current control technology to deliver steady incremental current while accommodating dynamic running demands. When battery voltage drops below a set threshold, the controller will cut motor power to prevent excessive drain, helping avoid deep-discharge stress on the pack.

• Constant current control smooths acceleration surges
• Automatic motor cut-off under low-voltage conditions
• Overload protection stabilizes riding speed under heavy load

What connectors and components are included in the kit?

The assembly includes a ZK2430-D-FS-ROHS 24V controller (specific model), a 4-pin male twist throttle, a 3-pin 2-wire charger port, KCD3 on/off switch and a pair of rubber handlebar grips. The charger port uses copper-core contacts to reduce resistance and charging losses.

• Controller model: ZK2430-D-FS-ROHS (not interchangeable with ZK2430-D-LD or ZK2430-D2-FS-ROHS)
• Throttle: 4-pin male twist throttle, 4-wire harness, no indicator lights
• Charger port: 3-pin, 2-wire male plug with copper core contacts
• Switch: KCD3 3-pin, 2-position ON/OFF (switch light needs 12V to illuminate)

How do I install this XIKOBY control module and what should I check first?

Installation typically requires removing the scooter cover to access the old controller, unplugging matching connectors, and mounting the replacement in the same location. Verify connector types, mounting hole alignment and that the throttle cable matches the 4-pin male plug before proceeding.

• Confirm your current controller model and vehicle version
• Match the throttle connector: 4-pin male required
• Use original mounting points and secure all plugs firmly

Who is this for: This XIKOBY 24V controller and throttle kit is for DIY scooter and electric dirt bike owners, repair shops, and anyone restoring a compatible Razor E200/E300 or MX350/MX400 model who needs an exact-fit replacement control module. It suits riders who want to restore reliable throttle response, add overload protection, or replace worn grips and charging port hardware. If you’re unsure about version compatibility or connector types, check your vehicle’s revision label or contact a technician before ordering.