XZWMY Weld-On Trailer Stake Pockets 8-Pack — Heavy-Duty 2x4 Open-Mouth Steel

The XZWMY 8Pcs Heavy Duty Weld-On Trailer Stake Pockets are solid steel brackets welded to a trailer frame to securely hold standard 2x4-inch wooden posts or steel stakes.

These unfinished weld-on stake pockets provide a simple, robust way to add removable sidewalls, tie-off points, or stakes to flatbed and box trailers. Built from thick raw steel, each pocket accepts a standard 2x4 stake and is sized for straightforward welding to existing trailer rails. The kit includes eight pockets, enough to outfit both sides of many small and medium trailer frames, and their bare finish allows fabricators to weld them into position and then paint or finish as desired.

How do these stake pockets attach to my trailer?

The pockets are designed for permanent installation by welding directly to the trailer frame or rail. Their open-top design accepts a 2x4 post or compatible steel stake, and the flat backing plate gives a broad weld surface for a secure bond.

• Weld-on mounting for long-lasting strength and durability
• Flat backing plate increases contact area for better welds
• Open-mouth pocket accepts standard 2x4 lumber or steel stakes
• Unfinished surface simplifies prep and weld penetration

What size stakes do these pockets fit and what are the dimensions?

Each pocket is sized to accept standard 2"x4" (nominal) posts and common trailer stakes. The external dimensions give a secure fit while allowing easy insertion and removal of stakes when needed.

• Overall pocket size: approximately 3.55" x 1.55" x 3"
• Designed for 2x4-inch wooden posts or similar steel stakes
• Depth accommodates the full thickness of typical trailer stakes
• Eight pockets included — enough for multiple mounting positions

Will these work on different trailer types and applications?

Yes — the brackets are versatile and intended for a range of trailer builds including flatbeds, box trailers, utility trailers, and truck beds. They create additional tie-down locations, removable sidewall anchors, or stake supports for hauling cargo securely.

• Suitable for flatbed and box trailers, plus truck beds
• Commonly used to install removable sideboards or stakes
• Adds tie-down points to improve load containment
• Raw steel finish allows post-weld painting or coating for corrosion protection

What should I know before welding and installing these pockets?

Because these are unfinished steel brackets, proper welding technique, surface prep, and corrosion protection are important. Position pockets evenly along the rail, tack in place, and confirm alignment before completing welds.

• Clean welding surfaces for best weld quality and penetration
• Tack-weld then re-check alignment before full welds
• After welding, coat or paint to prevent rust in service
• Use appropriate welding rod or wire for the trailer metal type

Who is this for: Fabricators, trailer owners, and contractors who need rugged, weld-on stake pockets to add removable stakes, sideboards, or extra tie-down points. If you build or repair trailers and want simple, heavy-duty brackets that accept standard 2x4 stakes and tolerate on-site finishing, the XZWMY 8-piece set offers a cost-effective, dependable solution.