YM E-Bright LED Hood Light Strip 70in RGB — Dynamic Startup Scan, Waterproof 12V DRL Accent

YM E-Bright’s 70-inch RGB LED hood light strip adds dynamic startup scanning and multicolor ambient lighting to 12V cars, trucks, SUVs and vans while operating as a bright, waterproof accent and DRL-style marker.

This flexible hood-beam strip blends decorative color control with practical visibility features. Designed for a 12V vehicle electrical system, it offers a dynamic startup 'scan' animation, steady illumination while driving, smartphone app color selection across millions of shades, and simple wiring to accessory (ACC), ground and turn-signal circuits. Constructed from silicone with heavy-duty nano tape, the strip is bendable, cuttable at marked points, and rated IP68 for protection against moisture—making it suitable for exterior engine-cover or grille installation when a 0.8 cm hood gap is available.

How does the dynamic scan startup work and what does it do?

The strip launches a running scan animation when the vehicle starts, then stays in a steady-on lighting mode while you drive. The animated startup attracts attention and the steady light acts as a visible accent or marker, increasing awareness of your vehicle in low light without being a primary safety device.

• Automatic run-through animation at engine start
• Switches to continuous illumination for driving
• Programmable patterns and colors via app
• Can complement turn-signal inputs for directional effects

Can I cut or bend the strip to fit my vehicle’s hood?

Yes—the silicone strip can be bent to match curves and cut at designated black marks to shorten it. Cutting alters the placement of scanning points, so plan the final length and sealing carefully; any trimmed end must be sealed to preserve waterproofing and function.

• Cut only at printed cut marks to maintain circuitry
• Bend gently—flexible silicone accommodates curves
• Seal cut ends before exposure to water
• Avoid high-pressure car wash spray directly on strip

What wiring and power connections are required?

Installation requires four wires: ACC (red) for accessory-switched power, ground (black), and two signal wires for left and right turn integration. Use a test probe to identify an ACC fuse circuit that is powered with the engine running and off when the engine is off for correct connection.

• Red = ACC power (switched with ignition)
• Black = negative/ground connection
• Yellow = left turn (+) signal input
• Blue = right turn (+) signal input

What color and waterproof performance can I expect?

The strip offers a wide RGB palette with up to 16 million color combinations and DIY color creation through the app. Rated IP68 for water resistance, the light tolerates normal road exposure but should not be blasted with high-pressure washers; cleaning from the side or a gentle rinse is recommended.

• 16 million color combinations via app control
• Soft silicone construction for even diffusion and brightness
• IP68 rating for water and dust resistance
• Includes hot glue stick and instructions for secure mounting

Who is this for: Drivers who want a bold exterior accent that combines showy RGB effects with practical nighttime presence will get the most value. It’s aimed at 12V vehicle owners—car, truck, SUV, van or pickup—with at least a 0.8 cm (0.31 in) gap between hood and body to safely house the 70-inch strip. The product also suits hobbyists who appreciate app-controlled lighting, custom colors, and integration with turn signals for coordinated effects. Note: this accessory enhances visibility and style but is not a substitute for approved vehicle lighting required by law.