AITKEN EKPM3 Fuel Pump Control Module for BMW (No Coding Required) — Direct Fit, Plug-and-Play

AITKEN EKPM3 is a plug-and-play fuel pump control module engineered to restore reliable fuel delivery on select BMW models without the need for programming.

This replacement EKPM3 (fuel pump control module) is designed to match factory fit and function for a range of BMW gasoline and diesel vehicles from the late 2000s to mid-2010s. It uses the same mounting and connector layout as OE units and carries cross-reference numbers used by BMW, so you can swap it in quickly and return the car to service. The module regulates fuel pump operation and monitors flow to help maintain steady performance during normal driving.

Which BMW models and part numbers does this module fit?

The AITKEN EKPM3 fits many BMW chassis and engine combinations produced between approximately 2008–2016. It lists multiple OE/OEM reference numbers so you can confirm compatibility with your vehicle before buying.

• Includes compatibility for BMW 1 Series M, M3 (2009–2010), X6 (2008–2010), Z4 (2009–2016).
• Covers 128i, 135i, 328i/328xi/328i xDrive, 335i/335xi/335d, and several 5 Series 528i/535i variants from 2008–2009.
• Cross-reference OE numbers: 16147426095, 16147411596, 16147407513 and others listed with the product.

How does this EKPM3 improve fuel delivery and engine protection?

The control module monitors and commands the fuel pump to match demand, reducing uneven flow and helping the engine receive a consistent fuel supply. By governing pump operation it reduces stress on the fuel system and avoids pressure spikes that can contribute to premature wear.

• Maintains stable fuel output across driving conditions for smoother throttle response.
• Monitors pump status and adjusts duty cycles to prevent overcurrent events.
• Works with factory sensors and wiring so existing engine management remains unchanged.

What is involved in installation and setup—do I need coding?

Installation is straightforward: the module is designed for direct replacement of the factory EKPM3 and plugs into the original connector. No coding or ECU programming is required; follow the installation steps and perform a road test to confirm proper operation.

• Plug-and-play replacement—no dealer coding necessary after installation.
• Perform an ignition/start and a short drive test to verify the warning lights and pump function.
• If the engine fails to start or a warning light persists, consult the included manual or contact AITKEN support for troubleshooting.

What should I check before ordering and after fitting the new module?

Before purchase, match the OE numbers on your existing part and confirm vehicle model year coverage. After fitting, inspect connectors, secure the unit in its mounting bracket, and verify that the fuel pump engages and the engine runs smoothly.

• Compare the module’s OE references with your old part to ensure proper match.
• Check for secure electrical connections and correct mechanical mounting.
• Run a short drive test and recheck for fault codes or dashboard warnings.

Who is this for: This AITKEN EKPM3 module is aimed at BMW owners, independent mechanics, and DIY enthusiasts who need an OEM‑style fuel pump control replacement for affected BMW models and prefer a plug‑and‑play solution without dealer coding. It’s appropriate for vehicles showing pump-related faults, intermittent fuel delivery, or when restoring original system function after fuel system service. If you’re unsure about fitment, provide your vehicle’s VIN or the old part’s OE number and consult the compatibility list prior to purchase.