Allstar Performance braided clutch line kit 48in — chrome & grey, preassembled -3AN to 90° hard-line

Allstar Performance 46100 is a pre-assembled braided clutch line kit that links a clutch master cylinder to a hydraulic throw-out bearing or to transmissions with internal clutches, featuring one straight -3AN end, one 90° 3/16" inverted-flare hard-line end, and an adapter fitting.

This kit delivers a ready-to-install, corrosion-resistant hose solution for converting or repairing hydraulic clutch plumbing. Built with braided steel reinforcement and chrome/grey finishes, the assembly simplifies routing in confined engine bays and reduces the need for custom hose fabrication. It includes a 1/8" male to -3AN adapter (ALL50000) so you can tie into common master cylinders or aftermarket fittings without searching for extra parts.

How does this clutch line kit connect to my clutch system?

The kit is made to bridge the clutch master cylinder and a hydraulic throw-out bearing or internal clutch transmission. One end uses a straight -3AN fitting while the other terminates in a 3/16" inverted-flare 90° hard-line end to fit existing hardline ports or bulkhead locations. The included ALL50000 adapter lets you attach to 1/8" male threads if needed.

• Pre-assembled #3 braided steel hose for direct connection
• -3AN straight end for aftermarket or AN-thread master cylinders
• 3/16" inverted-flare 90° hard-line end for factory-fitting compatibility
• Included 1/8" male to -3AN adapter for flexible hookups

What are the material and finish details I should expect?

This line uses braided steel reinforcement over a hydraulic-rated inner hose for strength and pressure handling. Fittings are finished in chrome with grey braided hose to resist corrosion and provide a clean under-hood appearance. The components are assembled and tested in the United States, ensuring consistent build quality.

• Braided steel exterior for abrasion and pressure resistance
• Chrome fittings for corrosion protection and visual appeal
• Pre-assembled to factory-style torque and sealing standards
• Lightweight construction — kit weight approximately 0.276 lbs

Will this kit fit my vehicle and is installation difficult?

Fit depends on your clutch master cylinder thread type and the routing space around your transmission. If your system accepts a -3AN or a 3/16" inverted-flare 90° hard-line, this kit will usually adapt with minimal modifications. Installation typically requires basic hand tools, line wrenches, and proper sealing/Teflon where recommended; bleeding the clutch is needed after install.

• Check master cylinder outlet threads: -3AN or 1/8" with supplied adapter
• 90° hard-line end aids routing in tight transmission tunnels
• Basic tools and a clutch-bleeding procedure required
• Compatible with hydraulic throw-out bearings and internal-clutch transmissions

Who is this for: This Allstar Performance 46100 clutch line kit is aimed at builders, restorers, and racers who need a reliable, ready-made hydraulic clutch hose that reduces fabrication time. It suits enthusiasts fitting aftermarket master cylinders, replacing worn hard lines, or connecting hydraulic throw-out bearings in compact engine bays. If you prefer a finished, corrosion-resistant hose assembly that includes an adapter for flexible hookup options, this kit streamlines installation and neatens the clutch plumbing on custom and performance projects.