DABAZUALY ignition coil A411000130 for Echo trimmers and handheld engines - direct-fit, OEM electrical match

High-performance replacement ignition coil A411000130 engineered to restore reliable spark and starting to compatible Echo engines and hedge trimmers.

This direct-fit ignition coil from DABAZUALY is designed as a replacement for a wide range of Echo models—covering ED, EDR, ES, ES-211, GT, HC, PAS, PB, PE, SRM, SHC, SV, TC and related series. It’s built to match OEM electrical characteristics so your small engine regains consistent ignition timing, improved start-up reliability, and stable idling when installed correctly. The part fits many serial-numbered model variants; always confirm your model and serial ranges before ordering.

Which Echo models and serial ranges does this coil replace?

This A411000130 coil fits many Echo handheld engines and trimmers across several families. It covers specific serial-number blocks for ED-200, EDR-210, ES-210/211, GT-200 series, GT-200R/GT-200i variations and more.

• ED-200, EDR-210 and multiple ES-210/ES-211 serial ranges listed in the specs
• GT-200 family including GT-200R, GT-200i and related serial numbers
• HC, PAS, PB, PE, SRM, SHC, SV and TC model lines referenced in the compatibility table
• Check your unit’s serial number against the product notes for exact fit

How will installing this coil affect engine performance?

Replacing a worn or faulty coil can restore consistent spark energy, which helps engines start easier and maintain steady running. The coil reproduces the ignition output required by the original equipment, improving combustion stability under normal operating loads.

• Improved spark consistency for quicker starting and fewer misfires
• Smoother idle and reduced stalling when ignition was the issue
• Compatibility with original wiring and mounting points for straightforward swap
• Durable insulation designed to handle heat and vibration common to handheld tools

What should I check before ordering or installing the coil?

Confirm model and serial numbers to ensure compatibility; incorrect fit wastes time and may not resolve the problem. Also inspect the spark plug, kill switch, wiring, and mounting hardware—these components can mimic coil failure.

• Verify your machine’s model and serial number against the compatibility list
• Inspect plug gap, leads, and connectors for corrosion or breaks
• Swap in a known-good spark plug to isolate ignition faults before replacing coil
• Follow manufacturer torque and clearance specs during installation

Can I install this part myself and what tools are needed?

Many owners with basic mechanical skills can replace the coil using common hand tools. Typical installation requires removal of shrouds, disconnecting the kill switch lead, and aligning the coil to the flywheel ground gap—refer to a service manual for exact procedures.

• Tools: screwdriver set, socket/wrench set, feeler gauge for air gap, ignition-safe pliers
• Disconnect spark plug lead and follow safety steps before service
• Set the coil-to-flywheel gap as specified in your Echo manual for correct timing
• Retest engine after installation to confirm spark and correct idle

Who is this for: This DABAZUALY A411000130 ignition coil is intended for owners, service technicians, and small-engine repair shops working on Echo handheld equipment and compact engines listed in the compatibility notes. It’s the right choice when ignition failures, hard starting, or intermittent running point to a faulty coil—provided you confirm serial-number compatibility and perform basic pre-install checks. If you’re replacing aging electrical components or rebuilding an engine short block for the models listed, this coil restores the ignition system to OEM-like function when installed per manufacturer guidance.