YEEHUNG 5.2" Vacuum Suction Cup Anchors 2-Pack — Heavy-Duty 220 lb Rated, Rubberized ABS Base

The YEEHUNG 2PCS 5.2" Vacuum Heavy Duty Suction Cup Holder Down Anchors are vacuum-pumped rubberized anchors designed to secure tarps, awnings, and accessories up to 220 lb on smooth, non-porous surfaces.

These two 5.2-inch vacuum suction anchors combine a rubberized ABS base, a clear vacuum indicator line, and a segmented plastic handle for organized operation. They create a strong, reversible anchor point without drilling or permanent hardware when attached to flat, hard surfaces such as glass, tiles, or polished metal. Each anchor is intended for temporary but heavy-duty use in outdoor and indoor settings where a reliable tie-down point is needed.

How do I install the YEEHUNG vacuum suction anchors correctly?

Preparation and a few simple steps are key: confirm the surface is smooth, hard, non-porous and larger than the suction cup, then dry and press into place. Use the pump action until the red vacuum-line indicator disappears, which signals full suction. Finish by routing your rope, cord, or hook through the handle.

• Clean and dry the attachment area thoroughly.
• Place cup flat, press center button, operate air pump until indicator line is gone.
• Attach rope or carabiner to the segmented plastic handle for tidy anchoring.
• Confirm suction before applying load and check periodically.

What surfaces and loads are these anchors safe for?

These suction anchors work only on hard, smooth, non-porous surfaces—think glass, glazed tile, marble, or polished metal. They are rated up to a maximum suction force of 220 lb under ideal conditions, but real-world holding capacity can vary with surface cleanliness, angle, and exposure to wind or movement.

• Approved: glass, smooth tiles, polished metal, sealed marble.
• Not approved: rough, porous, curved, or uneven surfaces.
• Max suction force: 220 lb (verify before relying on full capacity).
• Re-check vacuum indicator and condition regularly in outdoor use.

How do I remove and maintain these suction anchors for repeated use?

Removal is simple and gentle: lower the plastic handle to break the vacuum seal and lift the cup away. Maintain suction performance by keeping the rubberized base and target surface clean and free of grit, and store anchors away from prolonged direct sunlight when not in use.

• To remove: depress or gently lower handle to release vacuum and peel the cup off.
• Clean the rubber base with mild soap and water; dry completely before storage.
• Inspect the red indicator line each time; it shows vacuum integrity.
• Store in a cool, shaded spot to prolong rubber life.

Who is this for? The YEEHUNG 2PCS 5.2" Vacuum Heavy Duty Suction Cup Anchors are made for campers, van-lifers, installers of temporary awnings, boat owners, and DIYers who need strong, non-permanent anchor points on smooth surfaces. They suit anyone who needs quick setup and teardown for tarps, side awnings, shower curtains, or temporary fixtures without drilling holes. Avoid using them where the surface is porous or uneven, or where safety requires structural fasteners. If you have questions about fit or safe usage, contact YEEHUNG support for guidance before relying on full rated loads.